User guide

SUMMIT SWITCH INSTALLATION AND USER GUIDE 4-27
S UMMIT C OMMANDS
CONFIGURATION AND IMAGE COMMANDS
Table 4-19 describes conÞguration and image commands
config syslog <ipaddress> <facility>
{<priority>} {<subsystem>}
Configures the syslog host address and filter
messages sent to the syslog host. Options
include:
■ ipaddress — The IP address of the
syslog host.
■ facility — The syslog facility level for
local use.
■ priority — Filters the log to display
messages with the selected priority or
higher (more critical). Priorities include
critical, warning, and informational. If not
specified, only critical priority messages are
sent to the syslog host.
■ subsystem — Filters the log to display
messages associated with the selected
Switch subsystem. Subsystems include
Syst, STP Brdg, SNMP, Telnet, VLAN, and
Port. If not specified, all subsystems are
sent to the syslog host.
enable log display Enables the log display.
disable log display Disables the log display.
enable syslog Enables logging to a remote syslog host.
disable syslog Disables logging to a remote syslog host.
Table 4-19: Configuration and Image Commands
Command Description
save {config} {primary | secondary} Downloads a previously saved ASCII
configuration file from a specific IP host. You
must specify the IP address of the host and
the configuration filename.
Table 4-18: Logging Commands (continued)
Command Description
SUMMIT.BK Page 27 Thursday, September 25, 1997 12:33 PM