User guide

4-24 SUMMIT SWITCH INSTALLATION AND USER GUIDE

OMMANDS

Displays RIP-specific statistics. Statistics

include the following per interface:

■ Packets transmitted

■ Packets received

■ Bad packets received

■ Bad routes received

■ Number of RIP peers

■ Peer information

enable rip Enables RIP.

disable rip Disables RIP.

config rip add {vlan <name> | all} Configures RIP on an IP interface. If no VLAN

is specified, then all is assumed. When an IP

interface is created, per interface RIP

configuration is enabled by default.

config rip delete {vlan <name> | all} Disables RIP on an IP interface. When RIP is

disabled on the interface, the parameters are

not reset to their defaults.

enable rip aggregation Enables RIP aggregation of subnet

information on a RIP version 2 interface. The

default setting is enabled.

disable rip aggregation Disables the RIP aggregation of subnet

information on a RIP version 2 interface.

enable rip splithorizon Enables the split horizon algorithm for RIP.

Default setting is enabled.

disable rip splithorizon Disables split horizon.

enable rippoisonreverse Enables the split horizon with poison-reverse

algorithm for RIP. The default setting is

enabled.

disable rip poisonreverse Disables poison reverse.

enable rip triggerupdate Enables triggered updates.

Triggered update

are a mechanism for immediately notifying a

router’s neighbors when the router adds or

deletes routes, or changes the metric of a

route. The default setting is enabled.

disable rip triggerupdate Disables triggered updates.

enable rip exportstatic Enables the advertisement of static routes

using RIP. The default setting is enabled.

Table 4-17: RIP Commands (continued)

Command Description

SUMMIT.BK Page 24 Thursday, September 25, 1997 12:33 PM