User guide

SUMMIT SWITCH INSTALLATION AND USER GUIDE 4-21
S UMMIT C OMMANDS
IP ROUTE TABLE COMMANDS
Table 4-15 describes IP Route Table commands.
config iproute add default <gateway>
{<metric>}
Adds a default gateway. A default gateway
must be located on a configured IP interface.
config iproute delete default <gateway> Deletes a default gateway.
Table 4-15: IP Route Table Commands
Command Description
show iproute vlan {<name> | all | permanent |
<ipaddress> <netmask>}
Displays the contents of the IP routing table.
config iproute add default <gateway>
{<metric>}
Adds a default gateway to the routing table. A
default gateway must be located on a
configured IP interface . If no metric is
specified, the default metric of 1 is used.
config iproute delete default <gateway> Deletes a default gateway.
config iproute add <ipaddress> <mask>
<gateway> {<metric>}
Adds a static address to the routing table. Use
a value of 255.255.255.255 for mask to indicate
a host entry.
config iproute delete <ipaddress> <mask>
<gateway>
Deletes a static address from the routing table.
config iproute add blackhole <ipaddress>
<mask>
Adds a blackhole address to the routing
table. All traffic destined for the configured IP
address is dropped, and no Internet Control
Message Protocol (ICMP) message is
generated.
config iproute delete blackhole <ipaddress>
<mask>
Deletes a blackhole address from the routing
table.
Table 4-14: IP ARP Commands (continued)
Command Description
SUMMIT.BK Page 21 Thursday, September 25, 1997 12:33 PM