User guide

SUMMIT SWITCH INSTALLATION AND USER GUIDE 4-9

UMMIT

OMMANDS

USER ACCOUNT COMMANDS

Table 4-5 describes user account commands.

config devicemode [bridging | iprouting ] Configures the operating mode of the Switch.

Specify:

■ bridging — Layer 2 bridging functions only

■ iprouting — Bridging and IP unicast

routing functions

If this command is used to change the

operating mode of the Summit once it is up

and running, it causes the Switch to save the

configuration and reboot. The default

operating mode is iprouting.

unconfig switch {all} Resets all Switch parameters (with the

exception of defined VLANs and IP

addresses) to the factory defaults. If you

specify the keyword all, the IP addresses are

reset as well.

ping {continuous} {size <number>} <ipaddress> Sends ICMP echo messages to a remote IP

device. Specify:

■ continuous — ICMP echo messages

should be sent continuously.

■ size <n> — The size of the packet.

The continuous option can be interrupted by

pressing any key.

traceroute <ipaddress> Traces the routed path between the Switch

and a destination endstation.

clear counters Clears all statistical counters for the Switch

and ports.

Table 4-4: General Switch Commands (continued)

Command Description

SUMMIT.BK Page 9 Thursday, September 25, 1997 12:33 PM