User guide

4-6 SUMMIT SWITCH INSTALLATION AND USER GUIDE

OMMANDS

config devicemode [bridging | iprouting | ipmc ] Configures the operating mode of the

Switch. Specify:

■ bridging — Layer 2 bridging

functions only

■ iprouting — Bridging and IP unicast

routing functions

■ ipmc — Bridging, IP unicast routing,

and IP multicast routing functions

If this command is used to change the

operating mode of the Summit once it is

up and running, it causes the Switch to

save the configuration and reboot. The

default operating mode is iprouting.

config port <portlist> auto off {speed [10 | 100]}

duplex [half | full]

Manually configures the port speed and

duplex setting of one or more ports. For

more information on configuring ports,

refer to Chapter 3.

config time <time> Configures the system date and time. The

format for <time> is:

mm/dd/yyyy hh:mm:ss

The time uses a 24-hour clock format.

config vlan <name> ipaddress <ip_address>

{<mask>}

Configures an IP address and subnet

mask for a VLAN.

enable bootp vlan [<name> | all] Enables BOOTP for one or more VLANs.

For more information on using BOOTP,

refer to Chapter 3.

clear session <number> Terminates a Telnet session from the

Switch.

disable bootp vlan [<name> | all] Disables BOOTP for one or more VLANs.

disable port <portlist> Disables a port.

disable telnet Disables Telnet access to the Switch.

disable web Disables web access to the Switch.

delete account <username> Deletes a user account.

delete vlan <name> Deletes a VLAN.

Table 4-3: Common Commands (continued)

Command Description

SUMMIT.BK Page 6 Thursday, September 25, 1997 12:33 PM