User guide

3-14 SUMMIT SWITCH INSTALLATION AND USER GUIDE
A CCESSING T HE S WITCH
RESETTING AND DISABLING SNMP
To reset and disable SNMP settings, use the commands in Table 3-4.
CHECKING BASIC CONNECTIVITY
The Summit offers the following two commands for checking basic connectivity:
¥ ping
¥ traceroute
PING
The ping command enables you to send Internet Control Message Protocol (ICMP) echo
messages to a remote IP device. The ping command is available for both the user and
administrator privilege level.
The ping command syntax is as follows.
ping {continuous} {size <n>} <ip_address>
Options for the ping command are described in Table 3-5.
Table 3-4: SNMP Reset and Disable Commands
Command Description
disable snmp access Disables SNMP on the Switch.
disable snmp trap Prevents SNMP traps from being sent from the Switch.
Does not clear the SNMP trap receivers that have
been configured.
unconfig management Restores default values to all SNMP-related entries.
Table 3-5: Ping Command Parameters
Parameter Description
continuous Specifies ICMP echo messages to be sent continuously.
This option can be interrupted by pressing any key.
size <n> Specifies the size of the packet.
SUMMIT.BK Page 14 Thursday, September 25, 1997 12:33 PM