User guide

SUMMIT SWITCH INSTALLATION AND USER GUIDE 3-13
U SING SNMP
DISPLAYING SNMP SETTINGS
To display the SNMP settings conÞgured on the Summit, enter the following command:
show management
This command displays the following information:
¥ Enable/disable state for telnet, SNMP, and Web access
¥ SNMP community strings
¥ Authorized SNMP station list
¥ SNMP trap receiver list
¥ Login statistics
config snmp delete [<ipaddress> | all] Deletes the IP address of a specified
SNMP management station or all SNMP
management stations.
config snmp delete trapreceiver [<ip_address>
community <string> | all]
Deletes the IP address of a specified trap
receiver or all authorized trap receivers. If
you delete all trap receiver addresses,
any machine can have SNMP
management access to the Switch.
config snmp syscontact <string> Configures the name of the system
contact. A maximum of 255 characters is
allowed.
config snmp sysname <string> Configures the name of the Switch. A
maximum of 255 characters is allowed.
The default sysname is Summit. The
system name in the Summit prompt.
config snmp syslocation <string> Configures the location of the Switch. A
maximum of 255 characters is allowed.
Table 3-3: SNMP Configuration Commands (continued)
Command Description
SUMMIT.BK Page 13 Thursday, September 25, 1997 12:33 PM