User guide

9-8 SUMMIT SWITCH INSTALLATION AND USER GUIDE
IP U NICAST R OUTING
config rip rxmode [none | v1only | v2only |
any] {vlan <name> | all}
Changes the RIP receive mode for one or
more VLANs. Specify:
■ none — Drop all received RIP packets.
■ v1only — Accept only RIP version 1 format
packets.
■ v2only — Accept only RIP version 2 format
packets.
■ any — Accept both version 1 and version 2
packets.
If no VLAN is specified, the setting is applied
to all VLANs. The default setting is any.
config rip txmode [none | v1only | v1comp |
v2only] {vlan <name> | all}
Changes the RIP transmission mode for one or
more VLANs. Specify:
■ none — Do not transmit any packets on this
interface.
■ v1only — Transmit RIP version 1 format
packets to the broadcast address.
■ v1comp — Transmit version 2 format
packets to the broadcast address.
■ v2only — Transmit version 2 format
packets to the RIP multicast address
If no VLAN is specified, the setting is applied
to all VLANs. The default setting is v2only.
config rip updatetime {<delay>} Changes the periodic RIP update timer. The
default setting is 30 seconds.
disable rip Disables RIP.
disable rip aggregation Disables the RIP aggregation of subnet
information on a RIP version 2 interface.
disable rip splithorizon Disables split horizon.
disable rip poisonreverse Disables poison reverse.
disable rip triggerupdate Disables triggered updates
disable rip exportstatic Disables the filtering of static routes.
unconfig rip {vlan <name> | all} Resets all RIP parameters to the default VLAN.
Does not change the enable/disable state of
the RIP settings.
Table 9-3: RIP Configuration Commands (continued)
Command Description
SUMMIT.BK Page 8 Thursday, September 25, 1997 12:33 PM