User guide

SUMMIT SWITCH INSTALLATION AND USER GUIDE 9-7
C ONFIGURING IP U NICAST R OUTING
Table 9-3 describes the commands used to conÞgure RIP.
Table 9-3: RIP Configuration Commands
Command Description
enable rip Enables RIP. The default setting is disabled.
enable rip aggregation Enables RIP aggregation of subnet
information on a RIP version 2 interface. The
default setting is enabled.
enable rip exportstatic Enables the advertisement of static routes
using RIP. The default setting is enabled.
enable rippoisonreverse Enables the split horizon with poison-reverse
algorithm for RIP. The default setting is
enabled.
enable rip splithorizon Enables the split horizon algorithm for RIP.
Default setting is enabled.
enable rip triggerupdate Enables triggered updates. Triggered update s
are a mechanism for immediately notifying a
router’s neighbors when the router adds or
deletes routes, or changes the metric of a
route. The default setting is enabled.
config rip add {vlan <name> | all} Configures RIP on an IP interface. If no VLAN
is specified, then all is assumed. When an IP
interface is created, per interface RIP
configuration is enabled by default.
config rip delete {vlan <name> | all} Disables RIP on an IP interface. When RIP is
disabled on the interface, the parameters are
not reset to their defaults.
config rip garbagetime {<delay>} Configures the RIP garbage time. The default
setting is 120 seconds.
config rip routetimeout {<delay>} Configures the route timeout. The default
setting is 180 seconds.
SUMMIT.BK Page 7 Thursday, September 25, 1997 12:33 PM