Technical data

Dial Pulse to Tone Switchover 3-62
Chapter 3: System Features
MBX IP Description / Operations & Programming Guide
Dial Pulse to Tone Switchover
On a pulse dial CO line, the user can request the system to change the signaling mode from
pulse to DTMF, allowing the user to access outside facilities that require DTMF signals such as
banking services, voice mail, etc.
CONDITIONS
- In a Speed Dial, the
*
will automatically insert a pause before dialing the remaining
digits.
- This command is only recognized for analog pulse dial CO lines.
- Dial pulse to tone switchover is not available in the Redial features.
- For VoIP calls, pulse dialing is not available; switchover is not required or supported.
OPERATION
To switch from pulse to DTMF while on a pulse CO line:
Dial
*
(signaling change to DTMF).
ADMIN PROGRAMMING
CO Line Data
CO Dialing Type (PGM 160 - FLEX 10) … see details on page A-47
RELATED FEATURES
Speed Dial … see page 3-142
PGM 160 BTN RANGE DEFAULT
DIALING TYPE -- Signal type can be selected; DTMF, Pulse, R2MFC. 10 0: DTMF
1: PULSE
2: R2
DTMF
Release 1.0
November 2010