Technical data
TNET CM Attributes (PGM 331) A-148
Appendix A: System Programming Tables
MBX IP Description / Operations & Programming Guide
TNET CM Attributes (PGM 331)
Each LM (Local MFIM), which is part of a Central Control Network, must be defined with the IP
Address of the CM (Central MFIM) as well as the LM configuration data that will be sent to the
CM at the time the LM registers with the CM. The port counts define the ports, which are
allocated in the CM database for use by devices registered to the LM. The number of ports
defined in the database of each LM must be equal or less than the ports defined in the CM for
the LM (refer to PGM 332), in order to register properly.
1. Press the [PGM] button and dial 331.
2. Press the Flex button, 1-6 for the desired setting (refer to Table)
3. Use the dial pad to enter the required data (refer to Table).
4. Press the [SAVE] button to store the new data.
PGM 330 BTN RANGE DEFAULT
T-NET ENABLE -- enable T-NET function. 1 0:Off
1:On
Off
PGM 331 BTN RANGE DEFAULT
CH REGISTER REQ -- determines if the LM will attempt registration
with the CM; must be set to ON for proper registration.
10:Off
1:On
On
CH IP ADDRESS -- This field defines the IP address of the CM that
will be used by the LM.
2IPv4
address
0.0.0.0
CH IPKTS PORT -- In the TNET environment, the IP KTS protocol
signaling UDP port is defined; at present, this field is not used, do not
change this port number.
3 0001-9999 5588
CH TOTAL PORT -- Determines if the total number of Ports the LM
will request will be allocated by the CM for devices attached to the
LM; this value must be equal to or less than the port count in the CM
for the LM devices.
4 000-999 000
POLLING COUNT -- This field defines the maximum polling failures
an LM considers a WAN fault.
5 00-99 05
POLLING INTERVAL -- This field defines the interval time between
LM to CM polling attempts.
6 00-99 02
This
f
ea
t
ur
e is
n
o
t
a
va
ila
ble a
t
t
h
is t
im
e .
..
T
h
is
f
eat
u
r
e
is
n
ot
a
va
i
la
b
le a
t
t
his
t
im
e .
..
Release 1.0
November 2010