Technical data

CO Ring Assignment (PGM 167) A-54
Appendix A: System Programming Tables
MBX IP Description / Operations & Programming Guide
CO Ring Assignment (PGM 167)
Each CO line is assigned to stations or a feature code for an incoming call (Ring). Separate ring
assignments are made for Day, Night, and Timed Ring modes. The Ring signal can be set for
immediate or delayed ringing allowing other stations to be assigned ringing and answered prior
to a delayed station. If 'DISA Tone Service' feature code is assigned, DISA service is activated
at the CO line.
1. Press the [PGM] button and dial 167.
2. Use the dial pad to enter a CO line range. For a single CO Line, enter the same number
twice. For MBX IP-100, acceptable range is 01-80, for MBX IP-300, the acceptable range
is 001-240
3. Select Day mode and press the desired Flex button; refer to the following Table.
4. Use the dial pad to enter desired data for the Attribute.
5. Press the [SAVE] button to store the data entered.
"
PGM 167 BTN RANGE DEFAULT
SERVICE TYPE -- If service type is set as 0 -2,
ring option is applied to ring assigned stations.
Otherwise, if service type is set to 3, feature code
is activated on incoming call.
1 0: All Ring
1: First Idle
2: Circular
3: Feature Code
All Ring
FEATURE CODE -- If Service type is set to
Feature Code and valid feature code is
assigned, then assigned feature is activated
when there is an incoming call.
NOTE: Feature Code is not applied to rerouted
calls.
2 Valid Feature Code
(refer to PGM 115)
-
FEATURE DELAY -- If Service type is set to
Feature code, it can be delayed.
3 00-30 00
100 (0) -- Assigned station and delay value can
be displayed. Volume Up/Down key is used to
scroll data.
4- -
MEMBER ASSIGN -- To change station's ring
assign status, enter desired station range. (Max
30 stations can be assigned)
5 Start Station & End
Station
-
DELAY -- Enter delay value; if delay is 0, station
will start to ring immediately. If delay value is
deleted, the station will not ring.
Otherwise if delay is 1-9, the station will start to
ring after delay time(3 times of delay value)
5-1 0-9 Sta 100 (Port 0):delay 0
Others: not assigned
Release 1.0
November 2010