Technical data

CO Attribute I, II, III - PGM 160-162 A-49
Appendix A: System Programming Tables
MBX IP Description / Operations & Programming Guide
CO Attributes III (PGM 162)
LINE LENGTH -- LCO line length. 6 0: 0km
1: 3km
2: 5km
3: 7km
0km
ZONE NO -- Zone number of CO lines. 7 1-9 1
PROMPT LANGUAGE -- VMIB Prompt Index. 8 1-3 1
GAIN TABLE IDX -- Determines Gain Table for CO line. 9 1-3 1
PGM 162 BTN RANGE DEFAULT
CO ACCESS MODE -- CO lines can be set to blocked, or CO
line or Dedicated line.
1 0: Blocked Line
1: Normal CO Line
2: Dedicated Line
Normal CO
Line
DIGIT SENDING MODE -- CO lines can be set to send digit
with overlap or enblock method.
20:Overlap
1:Enblock
Overlap
MAX DGT LEN -- Number of dialed digits can be limited. 3 00-32 32
OVERLAP MIN DGT LEN -- Number of minimum digits can
be limited for overlap dialing.
4 00-32 00
CHECK PASSWORD -- Reserved for Password. Password
can be requested when the CO line is seized.
5 0: Off
1: On
Off
R2 CONNECT MODE -- R2 line connection mode. 6 0: End-to End
1: Link-by-Link
End-to End
R2MFC BACKWARD VAL -- R2MFC Backward Value. 7 01-15 01
DUMMY DIAL TONE -- When CO line is seized, dummy dial
tone can be provided for in case if PSTN does not provide it..
8 0: Off
1: On
Off
T1 NORMAL MODE -- Determines if Loop or Ground is
selected for each T1 Digital lines.
9 0: Loop
1: Ground
Loop
T1 DID MODE -- Determines if IMM, Wink, Delay Wink is
selected for each T1 DID lines
10 0: Immediate
1: Wink
2: Delay Wink
Wink
PGM 161 BTN RANGE DEFAULT
Release 1.0
November 2010