Technical data

Call Transfer 3-36
Chapter 3: System Features
MBX IP Description / Operations & Programming Guide
CO-to-CO Transfer Timer (PGM 220) … see details on page A-85
NO ANSWER PILOT HUNT GROUP -- The CO call is
routed to Pilot Hunt Group of the original destination.
6- -
NO ANSWER RING -- The call is routed to the same
destination again.
7- -
NO ANSWERThe CO call is routed to the transferred
station again.
Only possible for 'Transfer No Answer' case.
8- -
PGM 220 BTN RANGE DEFAULT
CO-CO TRANS TMR -- Determines the answer waiting time
when CO line is transferred to another CO line. If not answered
in this time, transferred CO call is disconnected.
1 000-300 secs 030
HOT-DESK LOGOUT TMR -- Determines the amount of time the
attendant receives recall after which the system will disconnect
the call.
2 00-24 hrs 00
ACNR PAUSE TMR -- This timer establishes the time between
ACNR attempts.
3 005-300 secs 030
PAGE TIME OUT TMR -- Determines the maximum duration of
a page after which the caller and Page Zone are released.
4 000-300 secs 15
PAUSE TMR -- A Timed pause of this duration is used in Speed
Dial and during other automatically dialed digits sent to the
PSTN.
5 1-9 secs 3
VM PAUSE TMR -- When the system sends a "Pause" to Voice
Mail using In-band signals, the Pause interval is defined by this
timer.
6 1-9 secs 3
VMIB-MSG MIN TMR -- This timer sets the minimum duration
allowed for a voice mail message in the system's VMIB.
Messages shorter than this period are not stored.
7 1-9 secs 4
VMIB-MSG MAX TMR -- This timer sets the maximum duration
allowed for the User Greeting in the system's VMIB.
8 00-999 secs 60
CALL-WAIT WARN TMR -- Determine the call-wait indication
tone repeat time.
9 010-1800 secs 030
CAMP-ON WARN TMR -- Determine the camp-on indication
tone repeat time.
10 010-1800 secs 030
PGM 173 BTN RANGE DEFAULT
Release 1.0
November 2010