Technical data

MBX IP Description / Operations & Programming Guide
Appendix A
System Programming Tables
The MBX IP system can be programmed to meet each customer's individual needs. System
programming may be accomplished by entering the "PROGRAM MODE" at an assigned Admin
Station or using the Web Admin (refer to the "MBX IP Web Administration Guide"). This section
provides general information.
Other sections include:
• Section 2 - provides a description for data entry using the Admin Station.
NOTE: Some parameters are available through Web Admin and not the Keyset
Admin.
• Appendix B - provides an index to database entries, default value charts for the
Flexible Numbering Plan, Fixed Function dial codes and the entire database. Indices
and charts are helpful references when entering data into the system database.
Initialization
When power is applied to the system or the MPB Reset button is pressed, the system will
initiate the "Power-up" routine. During the Power-Up routine the system will check the database
default switch (1st position of the MPB DIP-switch), refer to the "MBX IP Hardware and
Installation Guide".
If the switch is in the ON position:
the system will perform a simple Power-Up routine; clear all scratch-pad memory, load
run-time programs, establish communications with each registered board and DTIM/SLTM
gateway Module and MBX IP terminal, send RESTART commands and load appropriate
settings to the Modules and terminals. If a Module or terminal does not respond after
several attempts, the system places the device in an out-of-service mode but maintains
the database settings. Once the Power-up routine is complete, the system will conduct
normal operations.
If the database default switch is in the OFF position:
in place of the Power-Up routine, the system will perform the full Initialization procedure.
The initialization procedure will set the system database except DECT registration data to
default values, refer to Initialization section. Once initialization is complete, set the
initialization switch to the ON position to protect the database.
Release 1.0
November 2010