Technical data

Voice Over 6-33
Chapter 6: Digital Phone
MBX IP Description / Operations & Programming Guide
Voice Over
This feature allows Digital Phone Users, to receive a voice announcement through the handset
receiver while on an existing call (CO, IP or Intercom). The Voice Over (OHVO) will be muted
to not interfere with the existing conversation. The Called Station User may respond to the
Calling Party using Call Wait.
CONDITIONS
- The Receiving Station must be programmed to allow OHVO calls.
OPERATION
Digital Phone
Placing a Voice Over (OHVO) while receiving a Busy signal:
1. Dial the {Voice-Over code}, selected in Tenant Intercom Busy One-Digit service.
OR
2. Press a pre-programmed {OHVO} button.
3. After the splash tone is heard, begin announcement.
Responding to a Voice Over announcement:
While on the active call, press the [HOLD] button, activating the Call Wait feature.
PROGRAMMING
Station Data
Voice Over Access (PGM 133 - FLEX 9) … see details on page A-35
PGM 133 BTN RANGE DEFAULT
VOICE OVER ACCESS -- enable voice over
feature.
90: Disable
1: Enable
Disable
Release 1.0
November 2010