Technical data

Incoming Calling Line ID (ICLID) Call Routing 5-57
Chapter 5: CO/IP
MBX IP Description / Operations & Programming Guide
H.323 Incoming Attributes (PGM 362) … see details on page A-152
Incoming Calling Line ID (ICLID) Call Routing
The system can employ Incoming Calling Line ID (ICLID) to determine the routing of Incoming
external calls. Each CO/IP Line, including DID Lines, may be assigned to employ ICLID routing.
The System will compare the received ICLID to entries in the ICLID Routing Table. If a match
is found, the call will be routed to the destination defined in the ICLID Ring Assignment Table.
Destinations can be the VMIB, an external Voice Mail, a Station or a Station Group.
CONDITIONS
- If the received ICLID does not match an entry in the ICLID Route Table, the call is
routed according to CO Ring Assign Table.
- For analog CO Lines, the System will await receipt of a valid ICLID for the ICLID Ring
Timer. At expiration of the timer, if ICLID is not received, the call is routed based on
the type and other programming (Ring assignments, etc.) CO/IP Line.
- The ICLID received from the CO/IP Line must be a telephone number to match an
ICLID Route Table entry.
- If ICLID routing is enabled for a DID line, DID Call Wait is disabled.
- Beside the System ICLID Table, each station can have up to 10 individual ICLID
numbers.
G.711U CODEC -- usage of G.711U Codec Type. 6 0:Not Use
1:Use
Not Use
G.729 CODEC -- usage of G.729 Codec Type. 7 0:Not Use
1:Use
Not Use
G.723 CODEC -- usage of G.723.1 Codec Type. 8 0:Not Use
1:Use
Not Use
GK USED -- used to determine if Gatekeeper will be used. 9 0:Off
1:On
Off
PGM 362 BTN RANGE DEFAULT
FROM IP-- IP address associated with H,323 incoming calls. 1 - 0.0.0.0
INCOMING CO GRP NUM -- CO group number associated with
H.323 incoming calls.
2 01-72 -
PGM 361 BTN RANGE DEFAULT
Release 1.0
November 2010