Technical data

CO Line Service 5-25
Chapter 5: CO/IP
MBX IP Description / Operations & Programming Guide
Alternate Outgoing CO Service
A User can place an outgoing CO call and then can Hold or Transfer the Call to another User.
If the System cannot answer for an external Outgoing Call, a programmed service can be
provided or it can be routed into a programmed destination. This feature is applied by CO Line
Group by the Administrator.
• Recall No Answer – Station does not answer the Hold Recall, the call can be set for
routing destination, Disconnect, ATD, CO Ring Assign, Alt Ring table, Tone, or Pilot
Hunt.
• Transfer No Answer –Transferred call goes unanswered, the call can be set for routing
destination, Disconnect, ATD, CO Ring Assign, Alt Ring table, Tone, Pilot Hunt, or
Transfer Station.
• No Answer – If an incoming call goes unanswered, the call can be set for routing
destination, Disconnect, ATD, CO Ring Assign, Alt Ring table, Tone, or Pilot Hunt.
Operation If set, Alternate Outgoing CO Service is automatic.
CONDITIONS
- This feature can be set for each CO line.
- If attendant is not assigned and it calls an incoming CO call, it plays error tone.
- If there is no voice mail resource or all voice mail channels are busy, it plays error
tone.
- The destination is set differently according to Day, Night and Timed modes.
- If the destination is a ring table, all features of ring table can be applied.
PROGRAMMING
CO Line Data
FEATURE CODE -- If set to Feature Code and valid feature
code is assigned, then assigned feature is activated when
there is an incoming call.
NOTE: Feature Code is not applied to rerouted calls.
3 Valid Feature
Code (Refer to
PGM115)
-
FEATURE DELAY -- If Service type is set to Feature code, it
can be delayed.
4 00-30 (secs) 00
PGM 181 BTN RANGE DEFAULT
Release 1.0
November 2010