Technical data

Message Wait/Call Back 4-14
Chapter 4: Intercom
MBX IP Description / Operations & Programming Guide
SLT
To leave a MWI:
1. While receiving a Ring Back tone or No Answer on a Call Announce (H or P mode),
press the Hook-Switch.
2. Dial the {Message Wait/Call Back code}.
3. Hang-up, the MWI is activated.
To leave a MWI:
1. While receiving a DND tone, press the Hook-Switch.
2. Dial the {Message Wait/Call Back code}.
3. Hang-Up, the MWI is activated.
To retrieve a Station Message Wait:
Dial the {Message Wait/Call Back Answer code}.
To leave a Call Back (queue for a station):
1. While receiving a Busy Signal, press the hook switch.
2. Dial the {Message Wait/Call Back code}.
3. Hang up, and return to Idle.
To respond to a Call Back Recall:
1. When the Busy Station returns to Idle, the System initiates a Call Back.
2. Lift the handset, or press the [Speaker] button.
3. The previously Busy Station is called.
PROGRAMMING
System Data
Message Reminder Tone Timer (PGM 222 - FLEX 2) … see details on page A-87
PGM 222 BTN RANGE DEFAULT
MSG WIT ALERT TONE TMR -- A phone user will receive periodic
reminder tones of a message waiting at intervals based on this timer.
2 00-60
(minutes)
00
Release 1.0
November 2010