Technical data

Intercom Transfer 4-8
Chapter 4: Intercom
MBX IP Description / Operations & Programming Guide
Step Call (PGM 237 - FLEX 1)
Intercom Transfer
Users can Transfer an active Intercom call to other Stations in the System. Intercom calls can
be Transferred after announcing the call (Screened) or without announcing the call
(Unscreened).
The Intercom Station is placed on Exclusive Hold, and the Transfer Recall Timer is initiated; if
the timer expires before the Intercom call is answered, the call will Recall at the Transferring
Station until answered or abandoned.
CONDITIONS
- The [ICM] button provides an appearance for the transferred station; the LED
indicates status and pressing the button connects to the station.
- If the receiving Station is busy, the Transferring Station may Camp-On the call at the
Busy Station (refer to Camp-On).
- A Station in DND or out-of-service cannot receive a Transfer, and such attempts will
result in an Error tone.
OPERATION
Digital Phone
To perform a Screened ICM transfer, while on an ICM call:
1. Press [TRANS] button.
2. Dial the Station to receive the call.
3. When answered or on Splash tone, announce the call.
4. Hang-up, and return to Idle.
OR
1. Press the {DSS/BLF} button for the desired Station.
2. When answered or on Splash tone, announce the call.
3. Hang-up, and return to Idle.
PGM 237 BTN RANGE DEFAULT
STEP CALL -- determines if Step Call is enabled or disabled. 1 0: Disable
1: Enable
Disable
Release 1.0
November 2010