Technical data

System Networking 3-214
Chapter 3: System Features
MBX IP Description / Operations & Programming Guide
• A voice message cannot be left even though the VMIM/VSF is installed at a local
System.
• If the Call Originator does not answer the Call Back ring within Net Timer, the call will
be cleared.
• There are two modes: Connection Mode and Connectionless Mode; this can be set at
PGM 320 - FLEX 8.
OPERATION
To perform a CCBS (Call Back):
1. Dial the Station of the other System.
2. When a busy tone is received, the User can either,
(a) Press the [CALLBK] button,
(b) Press [TRANS] button and dial {Call Back Register Feature Code},
OR
(c) Dial the Call-Back digit set as Tenant Intercom Busy One-Digit service.
3. The call is cleared after the confirmation tone is received.
4. When the busy station returns to Idle; the originator will receive a Call Back ring.
5. When the originator answers the call-back ring, a new call to the Called Station will be
activated.
ADMIN PROGRAMMING
Voice Network
Network Basic Attribute (PGM 320) … see details on page A-145
PGM 320 BTN RANGE DEFAULT
NET ENABLE -- Enable Networking function. 1 0:Off
1:On
Off
NET CNIP ENABLE -- The name of the calling station is sent to the
called System between MBX IP systems. CNIP is displayed at the
called party Stations display based on the programming.
2 0:Off
1:On
On
NET CONP ENABLE -- Reserved for future usage. 3 0:Off
1:On
Off
NET SIGNAL METHOD -- Select the information element type for
QSIG supplementary service message.
4 0:UUS
1:FAC
UUS
Release 1.0
November 2010