Technical data

System Networking 3-207
Chapter 3: System Features
MBX IP Description / Operations & Programming Guide
Net Transfer
A Station User can transfer any kind of CO call to a Station on other systems by pressing the
[TRANS] button and dialing a transfer destination Station, as a Call Transfer within the same
system. There are two kinds of Transfer, Screened and Unscreened.
NOTE: There are two kinds of standard transfer method in QSIG and H.450; Transfer by Join and
Transfer by Rerouting. The main difference is how the connecting path is controlled between the
transferring and transfer destination Stations. Transfer by join uses an additional connecting
path for transferring the call to another station. Transfer by rerouting, uses a new connecting path
to transfer the call and the old connecting path of transferring station is cleared.
CONDITIONS
- If both of the transferred and destination Stations are located on the same system, the
networking path is cleared; the transfer call will be setup as an Intercom call.
- The Transfer will be canceled when the transferring Station User presses the flashing
[CO line access code] or [TRANS] button.
- Net Transfer calls do not recall at the origination Station.
- The User will hear an error tone if the Networking Path is unavailable.
- Net transfer is not activated at a Busy station.
VOIP CPN INFO -- 1: 001 VOIP CPN INFO 1
2: 001 VOIP CPN INFO 2
3: 001 VOIP CPN INFO 3
4: 001 VOIP CPN INFO 4
7- -
BLF SYSTEM IP -- IP Address of BLF Server used only when MBX
IP is configured with other systems for Voice Networking
8 - 0.0.0.0
BLF SYSTEM PORT -- UDP port for sending BLF message to BLF
Manager.
9 - 9500
FIREWALL ROUTING -- Select IP address (Firewall IP address or
Non-firewall IP address). If the destination system is in same VPN
then Non-firewall IP address should be sent. Otherwise the firewall IP
address should be sent. ON: Send firewall IP address
OFF: Send Non-firewall (Internal) IP address
10 0:Off
1:On
On
PGM 321 BTN RANGE DEFAULT
Release 1.0
November 2010