Technical data

System Networking 3-198
Chapter 3: System Features
MBX IP Description / Operations & Programming Guide
CM Attributes (PGM 331) … see details on page A-148
Fail-over PSTN Attributes (PGM 333) … see details on page A-149
PGM 331 BTN RANGE DEFAULT
CH REGISTER REQ -- determines if the LM will attempt registration
with the CM; must be set to ON for proper registration.
10:Off
1:On
On
CH IP ADDRESS -- This field defines the IP address of the CM that
will be used by the LM.
2IPv4
address
0.0.0.0
CH IPKTS PORT -- In the TNET environment, the IP KTS protocol
signaling UDP port is defined; at present, this field is not used, do not
change this port number.
3 0001-9999 5588
CH TOTAL PORT -- Determines if the total number of Ports the LM
will request will be allocated by the CM for devices attached to the
LM; this value must be equal to or less than the port count in the CM
for the LM devices.
4 000-999 000
POLLING COUNT -- This field defines the maximum polling failures
an LM considers a WAN fault.
5 00-99 05
POLLING INTERVAL -- This field defines the interval time between
LM to CM polling attempts.
6 00-99 02
PGM 333 BTN RANGE DEFAUL
T
ENABLE FoPSTN -- Determines if Fail-over operation is
enabled or disabled from the CM or LM.
10:Off
1:On
-
INIT FoPSTN TABLE -- Determines how to initialize the FO
Table.
2- -
FoPSTN Attributes 3 1-100 (MBX IP-100)
1-200 (MBX IP-300)
-
FoPSTN NUM PLAN -- Station numbers associated with the
remote System.
3-1 Max 16 -
FoPSTN CO GROUP -- Determines the CO Group of the
Local System that will be used to place calls to the stations
entered in the FO Numbering Plan, should a WAN failure
occur.
3-2 1-24 (MBX IP-100)
1-72 (MBX IP-300)
-
FoPSTN TEL NUMBER -- Determines the telephone number
the System should dial to place a call to the Stations entered
in the FO Numbering Plan, should WAN failure occur.
3-3 Max 10 -
Th
is
f
ea
t
ur
e is
no
t
a
va
ila
bl
e
at
t
his
t
i
me ..
.
This
f
ea
t
ur
e is
n
o
t
a
va
ila
ble a
t
t
h
is t
im
e
...
Release 1.0
November 2010