User guide

Release 1.0 SUMMIT IP Station User Guide April 2014

Using a Bluetooth Wireless Headset (IP-8024 only)

B-4

Appendix B: IP PHONE SETUP

6. Press the NEXT Soft button,

7. Press the OK soft button,

8. Enter the PIN code referring to the Bluetooth headset manual (default=0000),

9. Press OK Soft button.

To unpair the BTU headset:

1. Set the Bluetooth headset to pairing mode,

2. Press the [TRANS/PGM] button,

3. Dial 3,

4. Dial 2 (disable),

5. Press the OK Soft button.

To check BTU paired information:

1. Press the [TRANS/PGM] button,

2. Dial 3,

3. Dial 3,

4. Press the OK Soft button.

To use the BTU headset:

1. Press the [SPEAKER] button,

2. Press the "Call Start" button on the BTU headset,

3. Place call as you normally would.

To answer a call with the BTU headset:

1. When an incoming call is received, ringing will be present at the Station and the

BT headset,

2. Press the BT "Call Start" button, or press the [SPEAKER] button,

3. Lift the handset.

NOTE: When the BTU is used for a call, the [SPEAKER] button LED will illuminate and the speaker

mode cannot be used. If the phone handset is taken off-hook while in BT mode, the voice

path will directly be connected to the handset; press the [SPEAKER] button to activate the

BTU headset.