Technical data

Call Handling 1-74
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
• When handling an incoming call through DID, ICM or Transferring call:
- A call to a station which has the preprogrammed mobile extension is routed to both
the station and associated mobile extension.
- When an incoming call is answered at a station or at a mobile extension, the phone
that is not answered in the associated pair will stop ringing.
- If a mobile extension is answered, the associated station goes into Mobile-Ext In Use
State and displays the following: IN USE AT MOBILE EXT.
- Under the Mobile-Ext In Use State, the station cannot be used for dialing.
- If another station tries to call a station that is in the Mobile-Ext In Use State, the caller
hears a busy tone. In this case, Call Waiting is not supported. However, the caller can
leave a Message Wait at the extension (see 1-64).
• Also see "Remote Mobile Extension Control" on page 1-77.
ADMIN PROGRAMMING
Register a Mobile Extension
Set or verify CLI Transit
Use PGM 143, then FLEX 7, then ORI / CFW … see page 1-142.
Program or verify a Hunt Member
OPERATION / SETUP
To register a mobile extension number to a digital phone:
1. Press [TRANS/PGM], then 33.
2. Enter the mobile phone number that is being registered.
3. Press [HOLD/SAVE] to complete the registration.
Activate Mobile Extension -- used to enable mobile
extensions.
PGM 236 + FLEX 1 + 0
(Off) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Mobile Extension Hunt Call -- if set to ON and a station is a
member of Hunt group, then the Hunt call is served to its
Mobile extension also.
PGM 236 + FLEX 5 + 0
(Off) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Release 3.5
June 2010