Technical data

Call Handling 1-60
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
Headset
An industry-standard headset can be connected to a station (instead of using the handset or
speaker).
CONDITIONS
• The intercom signaling mode (HF/TN/PV - [TRANS/PGM] + 1 + 2) can be set in Headset
and speaker mode.
• In Headset mode, the User can select an incoming ring mode to hear ringing with the
speaker, headset, or both by Admin programming.
• The station will receive paging with the station speaker.
• To answer an intercom call in Tone mode, the User should press [SPEAKER].
• When an intercom call is received in Privacy mode, the station will be muted automatically.
User should press [MUTE] to answer the intercom call.
ADMIN PROGRAMMING
Set Headset Ring Mode
Change between Speaker/Headset
OPERATION / SETUP
To change the station from Speaker Mode or Headset:
1. Press [TRANS/PGM], then enter 76 (current answer mode will appear on the display).
2. Press 1 (Speaker mode) or 0 (Headset mode).
To change the Headset Ring mode:
1. Press [TRANS/PGM], then enter 75 (current answer mode will appear on the display).
2. Press one of the following:
1 = Speaker ring only 2 = Headset only 3 = Both
Speaker Ring -- determines if an incoming call will ring
to the speaker, the handset, or both.
PGM 111 + FLEX 10 + 1
(Speaker) + [HOLD/SAVE]
VALUES --
1 = Speaker (S)
2 = Headset (H)
3 = Both (B)
Speakerphone -- if value is set to ON, the speakerphone can
be used.
PGM 111 + FLEX 11 + 0
(Off) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Release 3.5
June 2010