Technical data

Call Handling 1-54
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
Flash
There are two Flash types available on the SBX IP:
• CO Flash - Provides station users with the ability to terminate or transfer an outside call or
transfer a call without hanging up. The flash type and duration of each CO line are
assigned by the system.
• Flash on ICM Call - This feature enables station users to utilize the [FLASH] button for
disconnecting pages and intercom calls.
CONDITIONS
• The Flash command is not activated on ISDN CO lines.
• A [FLASH] softkey button is located on each 24-button digital phone.
• A station that is not permitted to access CO line cannot initiate a flash.
• During a flash, the LED of the CO line will flash.
• Also, refer to the SBX IP Installation Manual.
ADMIN PROGRAMMING
Set Flash Command to CO Line Code
Use PGM 106, then FLEX 8 … for details, see the SBX IP Installation manual.
Set Flash Type
Set CO Flash Timer
Set SLT Hook-switch Bounce Timer
Flash Type Analog CO Lines -- designates the type of Flash
that is used.
PGM 141 + FLEX 7 + 0
(Loop) + [HOLD/SAVE
VALUES --
0 = Loop
1 = Ground
CO Flash Timer -- designates the length of time limit
for CO Flash. CO Flashing is available within this
timer; otherwise, the CO Line is released.
PGM 142 + FLEX 12 + 050
(100 msec) + [HOLD/SAVE]
VALUES --
Range = 000-300
SLT Hook Switch Bounce Timer (SLT only) -- designates
the length of time needed to detect a valid on- or off-hook
state.
PGM 182 + FLEX 1 + 01
Value (100 msec, 2 digits)
+ [HOLD/SAVE]
VALUES --
Range = 01-25
Release 3.5
June 2010