Technical data

Call Handling 1-52
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
Emergency Intrusion
If a station with this feature enabled calls a busy station, the caller can use this intrusion method
to break into the called station’s conversation.
CONDITIONS
• An Emergency Intrusion call is only possible when the feature has been enabled on the
calling station (see ADMIN PROGRAMMING).
• If the busy station is on a CO line call, the call is disconnected when Emergency Intrusion
is made.
• The busy station is connected to the Emergency supervisor after a short beep tone
indication.
• An Emergency Intrusion can not be used on a station that is:
- in the DND mode
- an Attendant station
- a Network DSS
• An Emergency Intrusion is connected to:
- the Master station of a "linked pair" if both the Master and Slave are busy (see "Linked
Pair Stations" on page 1-145).
- the Secretary Station instead of Executive station.
• Also see " Attendant Intrusion" on page 1-8 and "Forced Trunk Disconnect" on page 1-57.
ADMIN PROGRAMMING
Enable a Station as an Emergency Supervisor
OPERATION / SETUP
To activate Emergency Intrusion:
At a busy tone, enter the appropriate Emergency Intrusion code, then press # to
immediately connect user of the called station.
Emergency Supervisor -- if value is set to ON, this station can
make an emergency intrusion to another station.
PGM 112 + FLEX 24 + 0
(Off) + [HOLD/SAVE]
VALUES -
0 = Off
1 = On
Release 3.5
June 2010