Technical data

Call Handling 1-51
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
ADMIN PROGRAMMING
Enable One-Time Do-Not-Disturb
Use PGM 111, then FLEX 3 … see page 1-47.
OPERATION / SETUP
To activate One-time DND on a digital phone:
While on a call, press [DND/FWD]. The [DND/FWD] LED lights.
Do Not Disturb (DND) with Pre-Selected Message
A station can be programmed with a pre-selected message that will show up on the calling
party’s display.
CONDITIONS
• When [P-MSG DND] Admin is enabled for a station:
• Both internal and external calls are handled as if the station is in DND.
• When in DND mode, the called station does NOT receive any rings for incoming calls. An
internal caller hears a busy tone, and the pre-selected message appears on the caller’s
display.
• A external caller will hear a busy tone and see a busy message on their display (if
available).
• When [P-MSG DND] is disabled, the station being called receives an incoming call ring.
The caller hears ring-back tone.
• For DISA CO calls, an external user will hear a "Do not disturb" voice message telling
him/her to try again later.
• This feature cannot be used when the CO direct Ring Assign feature to station is enabled.
ADMIN PROGRAMMING
Enable P-MSG DND
Disable Ring Assign
Use PGM 144 … see page 1-13.
P-MSG DND -- if this value is set to ON, it allows the station to
use the preselected message feature.The station user must then
turn the feature on/or at the station.
PGM 113 + FLEX 16 +
0 (Off) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Release 3.5
June 2010