Technical data

Call Handling 1-39
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
• When the owner presses the pre-programmed button to be connected to the caller, the
voice message will not be saved.
• This is available for No Answer forward type.
ADMIN PROGRAMMING
Enable VMIB Access
Use (PGM 113), then FLEX 2 … see page C-21.
Assign Flex Button/Station Programming Button
Use PGM 115 … see page 1-55.
OPERATION / SETUP
To set the Operation Mode:
1. Press [TRANS/PGM]
2. Press the desired flexible button for programming.
3. Dial [XXX] + [0] to select the ring mode or dial [XXX] + [1] to select the speaker mode.
A confirmation tone sounds.
Camp-on
Camp-On allows you to set your phone to automatically call back a station that is busy. The
camp-on tone sounds at the busy station and the [HOLD/SAVE] LED flashes to notify the user
of the waiting call.
NOTE: An SLT user can notify a busy station of a CO or intercom call waiting.
CONDITIONS
• Camp-on is not applied to a station which is in DND mode, on a conference call, or placing
a page.
• The Attendant can override a station using the Camp-On feature.
• If the Stop Camp-on Tone is enabled, the Camp-On tone will not sound.
ADMIN PROGRAMMING
Enable Stop Camp-on Tone
Stop Camp-on Tone -- if value is set to ON, Camp on Tone is
not heard.
PGM 112 + FLEX 15 + 0
(Disable) + [HOLD/SAVE]
VALUES --
0 = Disable
1 = Enable
Release 3.5
June 2010