Technical data

Call Handling 1-33
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
ADMIN PROGRAMMING
Set Auto Fax Transfer CO
Set Fax Tone Detect Timer
Set Fax CO Call Timer
Automatic Privacy
By default, all conversations (on CO lines, the intercom, and conferences) are protected by
privacy (Automatic privacy). This prevents one station from accessing a line to listen in on a
conversation. However, this feature can be disabled by the station user as needed (via the HTP
feature). To allow a user to have the ability to enable or disable Automatic Privacy, the System
Attendant must make such a configuration in the system.
CONDITIONS
• If Automatic Privacy is enabled, a busy tone is heard when an attempt is made to access a
busy CO line.
• If Automatic Privacy is disabled, intruding station is connected to conversation in progress.
• When Automatic Privacy is disabled, privacy is still active for Intercom & Conference calls.
• A station can only override a privacy-disabled station.
• The station with Privacy disabled will hear an "intrustion" tone when another station
accesses the line.
Auto Fax Transfer CO -- if an Auto FAX CO line is
programmed, the system answers and detects the FAX
calling tone (1100Hz, 0.5sec ON/3sec OFF repeat tone)
from an incoming analog CO line. The system will route
this call to the last SLT port on basic MBU when tone is
detected within the programmed time.
PGM 161 + FLEX 17 +
Value (CO Line number)
+ [HOLD/SAVE]
VALUES --
Range = 01-36
(avail for
Analog CO line)
Fax Tone Detect Timer -- designates the amount of
time allowed to detect a FAX tone from the FAX CO
line before the call is routed to the ring assigned
Station for FAX CO line
PGM 182 + FLEX 13 + 05
seconds (2 digits) +
[HOLD/SAVE]
VALUES --
Range = 01-10 secs
(5 sec is suggested)
Fax CO Call Timer -- designates the amount of time
allowed to connect a call when a FAX tone is detected
from a FAX CO line; the call will attempt to be routed
to the appropriate FAX station.
Enter Bin number (01-10),
then PGM 182 + FLEX 14
+ 1 minute (1 digit) +
[HOLD/SAVE]
VALUES --
Range = 1-5 mins
Release 3.5
June 2010