Technical data

Call Handling 1-32
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
Select Alarm Signal Mode
OPERATION / SETUP
To terminate the alarm signal from an Attendant Station:
Press 565.
A confirmation tone sounds, and the alarm signal will be terminated at all assigned
stations.
Automatic Incoming Fax Transfer
The system automatically determines if an incoming call from the designated analog CO line is
for a fax or for a speech terminal by detecting the tone of the call (that is, 1100Hz, 0.5s ON/3s
OFF repeated). When the system detects a fax tone from the incoming line within the
predetermined time, the system transfers the call to the appropriate fax station. If the fax tone
is not detected within the predetermined time, the system interprets this as a normal phone call
(no fax), so the call is transferred to the specified station.
IMPORTANT: Only analog lines are enabled for using this feature.
CONDITIONS
• Only one CO line can be designated as a fax CO line. If a fax CO line is not programmed,
Automatic Fax Transfer cannot be activated.
• Station 17 is pre-programed station for fax transfers. Therefore, the fax machine should be
connected to the port for Station 17.
• If the fax CO line is not answered within the fax CO call time, the incoming call will be
disconnected.
• An outside caller connected to the fax CO line will hear a ring back tone when the system
detects a fax tone.
• To transfer calls from the fax to a fax station, do not assign CO ring to the fax Station 17.
• If a CO line is programmed for DISA, as well as for Automatic Fax Transfer, incoming calls
from that CO line are served as DISA calls. Therefore, if a user wants to call the fax
station, they will need to call Station 17 via the DISA call.
• When the fax machine goes idle after a fax call, the associated CO line is released.
• If the fax CO line is disconnected during a fax call, the CO line is released, and the fax
machine returns to an idle state.
Alarm Signal Mode -- if value is set to REPEAT, the Alarm
Signal is repeated until Alarm is reset.
PGM 163 + FLEX 4 + 1
(Repeat) + [HOLD/SAVE]
VALUES -
0 = Once
1 = Repeat
Release 3.5
June 2010