Technical data

Call Handling 1-31
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
Call Handling
Alarm
This feature allows you to set up an external contact to create an internal alarm. When the
contact is established and programmed, an alarm tone (single tone repeated per 1-min. interval
or a continuous tone) can be sent to designated stations within the system.
CONDITIONS
• An external contact should be connected to the alarm input.
• The alarm contacts should be dry (no voltage/current source connected).
• Single Line Telephones (SLTs) cannot receive alarm signals.
• An Alarm Reset can be programmed on a Flex button.
ADMIN PROGRAMMING
Enable Alarm
Set Alarm Contact Type
Select Alarm Mode
Alarm Enable -- if value is set to ON, Alarm is available. PGM 163 + FLEX 1 + 0
(Off) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Alarm Contact Type -- if value is set to OPEN, when alarm
relay is open, then alarm ring is provided.
PGM 163 + FLEX 2 + 1
(Close) + [HOLD/SAVE]
VALUES --
0 = Open
1 = Close
Alarm Mode -- if value is set to DOOR BELL, alarm signal is
provided only one time. If value is set to ALARM, alarm
signal is provided continuously depending on Alarm Signal
Mode (Flex 4).
PGM 163 + FLEX 3 + 1
(Alarm) + [HOLD/SAVE]
VALUES --
0 = Door Bell
1 = Alarm
Release 3.5
June 2010