Technical data

Remote IP Phone Setup E-57
Appendix E: Quick Start Topics
SBX IP 320 Programming & Operations Guide
Configuring IP Phone Settings
To verify connectivity to the VoIP card, ping the VoIP card from where the phone is located.
Setting up the IP Phone will vary dependent on the network infrastructure, IP Address Schema
and location of the System. You will need to have the following information to properly configure
the IP Phone.
1 - The IP Address of the VoIP card.
2 - Is IP Address information supplied dynamically (DHCP) or statically?
3 - An IP Address and Subnet Mask for the IP Phone (either static or DHCP).
4 - The Default Gateway IP Address (either static or DHCP).
NOTE: Note: If IP Addresses are static you will need to obtain the correct IP Address,
Subnet Mask and Default Gateway information from the IT Administrator.
Connect the IP Phone to the local network. It can be powered with an AC power adapter or a
port on a POE (Power Over Ethernet) Switch. The power adaptor is part #6899-PS. When
powered, the IP Phone will complete its boot sequence and attempt to connect to the VOIP
Card. If the phone is unable to connect to the VOIP card the display will show:
NO RESPONSE FROM MFIM
SET [*] - RESTART [#]
Press * to begin configuring the phone.
Use the Volume + and - to navigate the settings. Enter information as follows:
1. If you are prompted for a password : Dial 147*
2. At MODE [R/L] ? (This is the Remote/Local Setting.) All IP Phones are considered
remote to the SBX IP no matter where they are physically or logically. Set the mode to
REMOTE. Press # until the display shows:
MODE [R/L] ?
[REMOTE] – CHANGE[#]
Press Hold/Save to store the setting as REMOTE.
3. Press the volume + until DHCP ? appears. If IP Addressing is assigned via DHCP
this should be enabled. If IP Addressing is Static this should be disabled. Press #
until the display shows the correct state. Press Hold/Save to retain the entry.
4. Press the Volume + until MFIM IP ADDRESS (DOT:*) appears. This is the VOIB IP
Address Field. MFIM = VOIB. Enter the IP Address on the dial pad. Press the * to
enter a . (dot). For example, to enter 192.168.1.10, dial 192*168*1*10. Press
Hold/Save to retain the entry.
MFIM IP ADDRESS(DOT:*)
xxx.xxx.xxx.xxx (The VOIB IP Address)
Release 3.5
June 2010