Technical data

Call Control 1-30
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
Enable CO Dial Tone Detect
Walking Class of Service (Walking COS)
This feature allows temporary override of the toll restriction to allow toll call from previously toll
restricted phones. The authorization code can be used as a verified account code for SMDR.
CONDITIONS
• This feature can be used on both digital and SLT phones.
• This feature is available on a per-use basis only. The original programmed station COS
will be used when activating Walking COS, disconnecting a call, or pressing
[TRANS/PGM] to hold the call (and seize another line).
• When a wrong number is dialed, press [FLASH] to dial again without having to access
another idle CO line.
• The fee for a call with Walking COS will be charged according to the station authorization
code, not the actual station.
• When a user tries to use Walking COS at a station set to COS 7 (with temporary COS),
the call will follow the original COS of the station.
ADMIN PROGRAMMING
Access the Authorization Code Table
Use PGM 227 … see page 1-20.
OPERATION / SETUP
To activate Walking COS:
1. Press [TRANS/PGM], then press 23.
A confirmation tone sounds.
2. Enter the authorization code; the intercom dial tone sounds and the used extension
COS is temporarily changed. (Note: A CO call can only be placed one time.)
To program a Walking COS flex button:
1. Press [TRANS/PGM], then the applicable Flex button.
2. Press [TRANS/PGM], then 23.
3. Press [HOLD/SAVE] to store the setting.
CO Dial-Tone Detect -- when speed dial is activated, if this
value is set to ON, the system will detect a dial tone using CPT
instead of the pause timer.
PGM 160 + FLEX 6 + 0
(OFF) + [HOLD/SAVE]
VALUES --
0 = OFF
1 = ON
Release 3.5
June 2010