Technical data

Call Control 1-29
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
Access Canned Toll Tables
In addition to the basic toll restrictions, stations within COS 5 or 6 are subject to dial restrictions
based on the Canned Allow and Deny Tables. This program permits entries in the Canned Toll
Tables. Both the Allow and Deny table have 20 bins up to 14 digits.
Enable Incoming Toll Check
System Speed Zone
System Speed Zones consist of Speed bins & stations. Toll checks based on COS can be
applied to zones. Up to 10 speed number zones can be defined. Only stations allocated to
zones can access these bins. Speed bins not allocated to zones can be accessed by all stations
and no toll checks are applied.
ADMIN PROGRAMMING
Enable Speed Dial Access
Use PGM 112, then FLEX 9 … see page 1-168.
Assign System Speed Zone
Use PGM 232 … see page 1-168.
VALID DATA FUNCTION LCD DISPLAY
0-9, *, # Number as dialed
[DND/FWD] Don’t Care "D"
Allow Table -- used to check, whether the dialed
digits by COS 5 and COS 6 station is matched with
the allowed toll pass digits. NOTE: Allow table of
canned toll is only used when the COS of dialed
station is COS 5 or 6.
PGM 225 + FLEX 1 + VALUE
(refer to Allow Table) + Allow
Number (Max 14 Digits; 0-9, #, *)
+ [HOLD/SAVE]
VALUES --
Range = 01-20
Deny Table -- used to check whether the dialed
digits by COS 5 and COS 6 station is matched with
the denied toll pass digits. NOTE: Deny table of
canned toll is only used when the COS of dialed
station is COS 5 or 6.
PGM 225 + FLEX 2 + VALUE
(refer to Deny Table) + Deny
Number (Max 14 Digits; 0-9, #, *)
+ [HOLD/SAVE]
VALUES --
Range = 01-20
Incoming Toll Check -- if this value is set to ON, the system
checks for tolls applied to incoming CO calls.
PGM 161 + FLEX 16 + 0
(OFF) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Release 3.5
June 2010