Technical data

Call Control 1-21
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
Enter the appropriate Bin number (001-200), then follow the procedure as shown:
Set DISA Account Code
Use PGM 141 … see page 1-130.
Access CO Line Group Account
Set Loop LCR Account Code
Set 5 Digit Authorization Code Usage
Authorization Code Table -- if the dialed
Authorization code is verified, a CO dial tone
will be presented. Otherwise, an error tone
will be heard and access to the group will be
denied. Stations or Admin programming can
enter authorization codes. The Administrator
can see and change station passwords-no
duplicate entries. The total number of
Authorization Codes is 200 entries.
PGM 227 + FLEX 1 +
Authorization Code (3-11
digits; Range = 0-9) +
[HOLD/SAVE]
VALUES --
Default = Not Assigned
Authorization codes can be
programmed as 5 digits or
flexible length (3-11 digits);
refer to PGM 161 - FLEX21
Day COS of Authorization Code -- Day COS
of stations can only be viewed; COS for
extra entries can also be assigned.
PGM 227 + FLEX 2 +
Class of Service Value +
[HOLD/SAVE]
VALUES --
Range = 1-9
Night COS of Authorization Code -- Night
COS of stations can only be viewed; Night
COS for extra entries can also be assigned.
PGM 227 + FLEX 3 +
Class of Service Value +
[HOLD/SAVE]
VALUES --
Range = 1-9
CO Line Group Account -- if this value is set to ON, the CO Line
user will be prompted to enter an authorization code to access
this CO Line.
PGM 141 + FLEX 9 + 0
(Off) + [HOLD/SAVE]
VALUES --
0 = Off
1 - On
Loop LCR Account Code -- if value is set to ON, the Station
User must enter an Account Code to use Loop LCR.
PGM 111 + FLEX 16 + 0
(Off) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
5 Digits Authorization Code Usage -- if value is set to ON,
Authorization code is programmed as 5 digits fixed length.
Under this mode, 5 digits of the authorization code should be
entered when related features are activated. If this value is set
to OFF, Variable Authorization code (3-11 digits) is used.
PGM 161 + FLEX 21 + 0
(Off) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Release 3.5
June 2010