Technical data

Calls to Voicemail C-14
Appendix C: Voicemail Service
SBX IP Programming & Operations Guide
ADMIN PROGRAMMING
Set No Answer to VMIB Timer
Enable Auto Forward to VMIB
Remote Control
By directly accessing their station via DID/DISA or as an intercom (ICM) caller, a station user
can retrieve messages, change the user greeting and other station settings, (for example,
cancel Call Forward to VMIB, etc.).
CONDITIONS
• Press * from any sub-menu to access the main menu.
• Connection will be dropped if a digit (selection) is not entered within the time set in the
Inter-digit timer - see ADMIN PROGRAMMING.
• If the VMIB User Record Timer expires while a user greeting is being recorded, only the
segment of the greeting that was recorded prior to the timer expiration is saved.
ADMIN PROGRAMMING
Set VMIB User Record Timer
Use PGM 181, then FLEX 3 … see page C-6.
Set Inter-digit Timer
Use PGM 181, then FLEX 8 … see page 1-150.
Set VMIB Message Rewind Timer
Use PGM 181, then FLEX 17 … see page C-9.
Forward to VMIB Timer -- If the Auto Forward To VMIB
feature (PGM 113 - FLEX 14) is set for a station, the call is
automatically forwarded to voice mail after this timer
expires, so the caller can leave a voice message.
PGM 181 + FLEX 20 + 20
seconds (2 digits) +
[HOLD/SAVE]
VALUES --
Range = 01-60
Auto Forward to VMIB -- when this value is set, a call is
answered by the voice mail, when the FWD to VMIB
timer expires.
PGM 113 + FLEX 14 + 1
(On) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
(PGM 181 - F20)
Release 3.5
June 2010