Technical data

Call By IP Address B-2
Appendix B: VoIP Service
SBX IP Programming & Operations Guide
Set VOIB IP
Set Ring Assignment
Use PGM 144 … see page 1-13.
OPERATION / SETUP
To make use an IP address to make a call:
1. Press the appropriate CO line, {POOL}, or CO button.
-or-
Dial the CO line, or Group code.
A dial tone sounds.
2. Enter the IP address.
NOTE: Use * instead of the dots in the IP address (for example, if the IP Address is
156.147.3.201, the following would be entered: 156*147*3*201)
3. Press # to place the call.
4. If the entered destination is a user within the SBX IP system, ringing follows the
pre-defined Ring Assignment.
IP Address (Skip:#) -- used to set the IP address of the
VOIP board.
PGM 340 + FLEX 1 + IP
Address (VALUE) +
[HOLD/SAVE]
VALUES --
12 digits
Gateway Address (Skip:#) -- used to set the gateway
address of the VOIP board.
PGM 340 + FLEX 2 + IP
Address (Value) +
[HOLD/SAVE]
VALUES --
12 digits
Subnet Mask (Skip:#) -- used to set the subnet mask of
the VOIP board.
PGM 340 + FLEX 3 +
Subnet Mask (12 digits) +
[HOLD/SAVE]
VALUES --
Default =
255.255.255.0
DNS Address (Skip:#) -- used to set the DNS address of
the VOIP board.
PGM 340 + FLEX 4 +
DNS Address +
[HOLD/SAVE]
12 digits
Release 3.5
June 2010