Technical data

Networking Programming Tables A-25
Appendix A: Networking Services
SBX IP Programming & Operations Guide
Net Number Plan CO Line Group -- used to
select the CO line group for routing networking
calls.
PGM 324 + FLEX 3 + Net CO
Line Group + [HOLD/SAVE]
VALUES --
Range = 00-24
CPN IP Information -- the IP address for VoIP
(CPN info 1-CPN info 4). If the destination
system has several IP addresses and all
channels of the 1st address is busy, then the
system tries to connect to the 2nd address.
PGM 324 + FLEX 4 + FLEX 1
(refer to VALUES) + IP
Address (12 digits) +
[HOLD/SAVE]
VALUES --
FLEX 1 = 1ST IP addr
FLEX 2 = 2ND IP addr
FLEX 3 = 3RD IP addr
FLEX 4 = 4TH IP addr
Alternate Speed Dial Bin -- alternate number
used when the networking path experiences
fatal problems.
PGM 324 + FLEX 5 + Speed
Bin Number + [HOLD/SAVE]
VALUES --
Range = 2000-2499
Destination MPB IP -- designates the IP
Address of the system used to support DECT
mobility service.
PGM 324 + FLEX 6 + IP
Address + [HOLD/SAVE]
VALUES --
12 digits
Digit Repeat -- when value is set to YES, the
PSTN is not connected with the PSTN line
directly, but is connected by another networking
system.
PGM 324 + FLEX 7 + 0
(Value) + [HOLD/SAVE]
VALUES --
0 = No
1 = Yes
CO ATD Code CLI -- used to determine whether
the CLI number is sent to the PX.
PGM 324 + FLEX 8 + 0
(Value) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Firewall Routing -- If networking system uses
the same network, set Firewall Routing to NO
(Off) and local IP address will be used for the
networking feature.
If the networking system uses a different
network, set Firewall Routing to YES (On) and
the Firewall IP address will be used for the
networking feature.
PGM 324 + FLEX 9 + 0
(Value) + [HOLD/SAVE]
VALUES --
0 = No
1 = Yes
Authorization Code COS Use -- if value is set to
YES, the COS of Transit-out call will be
determined based on the password that the user
dialed. The COS of the password in the
AUTHORIZATION CODE TABLE (PGM 227) is
used.
PGM 324 + FLEX 10 + 0
(Value) + [HOLD/SAVE]
VALUES --
0 = No
1 = Yes
SMDR Dial Hidden -- If value is set to ENABLE,
Dialed number of CO Call is not showed on
SMDR record.
PGM 324 + FLEX 11 + 0
(Value) + [HOLD/SAVE]
VALUES --
0 = No
1 = Yes
FEATURE / DESCRIPTION PROCEDURE DEFAULT / VALUES
Release 3.5
June 2010