Technical data

Internet Protocol (H.450) A-20
Appendix A: Networking Services
SBX IP Programming & Operations Guide
ADMIN PROGRAMMING
Set CO Service Type (to ISDN DID)
Use PGM 140 … see page 1-135.
Set ISDN CO Line Attributes - DID Conversion Type
Use PGM 143 … see page 1-125.
Enable DID Receive Digit and DID Digit Mask
Use PGM 146 … see page 1-121.
Access Flexible DID Table
Use PGM 231 … see page 1-127.
Access Flexible Station Numbering Plan
Use PGM 105 … see the SBX IP Installation Guide.
Set Network CO Group and Type (to 01 and NET)
Use PGM 322, then FLEX 1 and 4 (respectively), see page A-24.
Enable Networking Feature
Use PGM 320, then FLEX 1, see page A-22.
Set IP Address of Destination System's VOIB
Use PGM 324, then FLEX 4, see page A-25.
Configure the VOIP networking between Systems A & B as shown below:
At System A
:
1. Use (PGM 105), press [SPEED], and enter 100 and 199.
2. Press [HOLD] to store the setting.
At System B
:
1. Use (PGM 105) + [SPEED], and enter 200 and 299.
2. Press [HOLD] to store the setting.
Release 3.5
June 2010