Technical data

Internet Protocol (H.450) A-18
Appendix A: Networking Services
SBX IP Programming & Operations Guide
ADMIN PROGRAMMING
Set Networking Basic Attributes
Use PGM 320 … see page A-22.
Set Networking Supplementary Attributes - Transfer Mode
Use PGM 321 … see page A-23.
Set Networking CO Line Attributes
Use PGM 322 … see page A-24.
Access Networking Routing Table - Numbering Plan
Use PGM 324 … see page A-24.
OPERATION / SETUP
See "Call Transfer" on page 1-184.
Security of Transit-Out Code with registered IP
If Transit-out Security feature is enabled, the received IP (in all received setup packets for the
Transit-Out feature (see page A-9) is checked with the registered IP. If the IP is verified, the
Transit-Out feature is initiated. However, if the IP is not validated, the call is automatically
disconnected.
CONDITIONS
• Once Transit-Out Security, IP numbers must be set at CPN Info in Network Number Table
(see Admin Programming).
• The verification that occurs with Transit-out Security is a comparison between the
received IP in setup packet and registered IP. The system compares the received IP
number with all registered CPN Info IP at the NET Number table. Transit-Out Security is
only used on a VOIP CO line; the setup packet for Transit-Out arrives from a VOIP line.
• If a received IP does not match with any registered IP in the Network Number Table, the
call is disconnected.
ADMIN PROGRAMMING
Access NET Number Table
Use PGM324 … see page A-24.
Release 3.5
June 2010