Technical data

Internet Protocol (H.450) A-2
Appendix A: Networking Services
SBX IP Programming & Operations Guide
Display Messages (Absent Text Message)
This feature is available within the networking connection environment - see "Custom Display
Text Message (Absent Text Messages)" on page 1-70.
This means that if a station user enables the Absent Text Message feature at his/her station, an
incoming call to this station (even one from another networking system) will receive the
designated text message (displayed on the calling station LCD).
CONDITIONS
• A text message will be displayed on the LCD of the networked calling station, while the
called station receives the ring signal.
OPERATION / SETUP
Operation of the feature is automatic when a call is received from a station within, or from,
another networked system.
Attendant Call Service (CAS)
An Attendant call from a station on a networked system can be routed to the Centralized
Attendant (CA) of the Call Attendant Service (CAS) master system. This call will be queued if
all centralized Attendants are busy.
CONDITIONS
• Intercom calls are routed to network Attendant if system Attendant is in ATD_DND mode.
• CO calls can be routed to network Attendant only if the DID/DISA destination is
designated as ATD, and the ring is not assigned to a station.
ADMIN PROGRAMMING
Enable/Disable Networking CAS
Use PGM 320 … see page A-22.
Assign Flex Button/Station Programming Button
Use PGM 115 … see page 1-55.
Set Attendant Assignment
Use PGM 164 … see page 1-6.
Set DID/DISA Destination
Use PGM 167 … see page 1-126.
Release 3.5
June 2010