Technical data

Other Programming Tables 1-225
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
CO Line CID Attributes (PGM 147)
Slot Base Program (PGM 155)
Board Attributes (PGM 155)
Russia CID -- N/A
(Russia only)
PGM 147 + FLEX 3
through FLEX 9
VALUES --
R2 CRC Check -- if value is set to Enable, the R2 CRC is
checked.
PGM 155 + Slot Number
of E1IB (06) + FLEX 1 + 0
(VALUE) + [HOLD/SAVE]
VALUES --
0 = Disable
1 = Enable
Distance Coefficient Setting -- when the switch for selection
long loop on the board is set to "Long", the gain value is set
according to the Distance Coefficient. (Applied to
LCOB/SLIB/HYBRID.)
PGM 155 + Slot Number
of LCOB/SLIB/HYBRID +
FLEX 2 + 0 (0 Km) +
[HOLD/SAVE]
VALUES --
0 = 0 Km
1 = 3 Km
2 = 5 Km
3 = 7 Km
DCO IP Address -- IP Address of E1IB. PGM 155 + Slot Number
of E1IB (06) + FLEX 3 +
IP addr + [HOLD/SAVE]
--
DCO Gateway IP Address -- Gateway IP Address of E1IB. PGM 155 + Slot Number
of E1IB (06) + FLEX 4 +
IP addr + [HOLD/SAVE]
--
DCO Subnet Mask -- Subnet Mask of E1IB. PGM 155 + Slot Number
of E1IB (06) + FLEX 5 +
Subnet mask +
[HOLD/SAVE]
--
DCO Server IP -- Server IP Address of E1IB. PGM 155 + Slot Number
of E1IB (06) + FLEX 6 +
IP addr + [HOLD/SAVE]
--
DCO Master Clock -- set this board as a Master party or Slave
party.
PGM 155 + Slot Number
of E1IB (06) + FLEX 7 + 0
(SLAVE) + [HOLD/SAVE]
--
PLL SSCG (N/A) -- for hardware engineering tests. PGM 155 + FLEX 8 + 0
(Disable) + [HOLD/SAVE]
VALUES --
0 = Disable
1 = Enable
Release 3.5
June 2010