Technical data

Rerouting 1-192
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
ADMIN PROGRAMMING
Enable Direct Call Pick up Code
Use PGM 107, then FLEX 6. Refer to the SBX IP Installation Guide.
PLA Priority Setting - Pick-up Priority
Use PGM 173 … see page 1-131.
Set Intercom Tenancy Group
Use PGM 120 … see 1-64.
OPERATION / SETUP
To assign Direct Call Pick-up Flex button:
1. Press [TRANS/PGM], then the Flex button to be assigned.
2. Press 7, the press [HOLD/SAVE] to store the setting.
To pick up a call ringing at another station:
1. Go off-hook, then press 7 (the Direct Call Pick-Up code).
-or-
Press the programmed {Direct Call Pick-up} Flex button (if available).
2. Dial the station number of the ringing station.
Group Call Pick Up
CONDITIONS
• Intercom calls, incoming CO Lines, recalling CO Lines and transferred CO Lines can be all
supported for Group Pick Up. An intercom call cannot be picked up at a station in Hold or
Park mode.
• A CO line, CO or {POOL} button is required to pick-up a CO Line call.
• Queued callback and private line calls cannot be picked up.
• This feature can be used to answer intercom calls to a Doorbox (see 1-93).
• When several calls are queued at a station or Hunt Group, the pick-up order depends on
Pick-up Priority set in ADMIN PROGRAMMING.
• When the same types of CO lines are queued, the CO line that has been queued the
longest is picked up first.
• This feature is only allowed within the Intercom Tenancy Group to which both the ringing
and answering station belong. A station cannot pick up any call ringing at a station that
belongs to "denied" Intercom Tenancy Group set in ADMIN PROGRAMMING.
Release 3.5
June 2010