Technical data

Rerouting 1-190
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
ADMIN PROGRAMMING
Call Park Recall Timer
OPERATION / SETUP
To park a call:
1. Press [TRANS/PGM].
2. Enter the parking location 601-608, then go on -hook.
3. Page the user (if appropriate) with the location of the parked call for retrieval.
To retrieve the parked call from a digital phone:
1. Go off-hook.
2. Enter the location of the parked call.
Park and Page
This feature allows a caller to page a user when the caller reaches the user’s voice mail. This
process places the call in a System Park Zone, then have the user paged.
CONDITIONS
• The target mailbox must have the COS associated with this feature enabled.
• This feature is only supported for CO callers.
• The call is sent to the operator:
- If the call remains unanswered in the park location for the duration of the Call Park
Recall timer, the call transfers to the operator.
- After one attempt
• This setting must be made for each station through ADMIN PROGRAMMING. The default
setting is for this feature to be disabled for each station.
• PGM 6* must be used to record the user’s name at each station with this feature enabled.
• PGM 6, then 1 must be used to record the user’s greeting (including paging instructions -
shown below) at each station with this feature enabled.
The system places the caller into a parking zone (beginning at the first available zone),
then accesses the All-Call page. A pre-recorded broadcast sounds through the paging
system: "Call for [user] in location XXX".The system then goes on-hook.
Call Park Recall Timer -- designates the amount of time
before a call placed in a call park location will recall at the
station that placed the call on park.
PGM 180 + FLEX 2 +
120 seconds (3 digits)
+ [HOLD/SAVE]
VALUES --
Range = 000-600
Release 3.5
June 2010