Technical data

Rerouting 1-188
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
• Hold Preference - If System Hold is set as the preferred Hold, [HOLD] is pressed once for
System Hold, and twice for Exclusive Hold. The reverse is also true, if Exclusive Hold is
set as the preferred Hold, [HOLD] is pressed once for Exclusive Hold, and twice for
System Hold.
ADMIN PROGRAMMING
Set Hold Preference - allows user to toggle between Hold types (System or Exclusive)
Set Attendant Recall Timer
Use PGM 180, then FLEX 1 … see page 1-87
Set Exclusive Hold Recall Timer
Set Hold Recall Timer
Use PGM 180, then FLEX 5 … see page 1-10
Set System Hold Recall Timer
Set Transfer Recall Timer
Use PGM 180, then FLEX 7 … see page 1-182.
Enable Automatic Hold
Hold Preference -- there are two types of Hold: System Hold
and Exclusive Hold. If a call is held in System Hold, any
station can retrieve the call; in Exclusive Hold, only the
holding station can retrieve the call.
PGM 160 + FLEX 8 + 1
(System) + [HOLD/SAVE]
VALUES --
0 = Exclusive
1 = System
Exclusive Hold Recall Timer -- designates the amount of
time before a call placed on System Hold will recall at the
station that placed the call on hold.
PGM 180 + FLEX 4 +
060 seconds (3 digits)
+ [HOLD/SAVE]
VALUES --
Range = 000-300
Sys Hold Recall Timer -- designates the amount of time
before a call placed on System Hold will recall the station
placing the hold.
PGM 180 + FLEX 6 +
030 seconds (3 digits)
+ [HOLD/SAVE]
VALUES --
Range = 000-300
Automatic Hold -- while seizing a CO line, the station user
secures another CO line by pressing the {CO} button. If this value
is set to ON, the previously seized CO line will automatically be
placed on Hold. For Attendant, default value is ON.
PGM 112 + FLEX 2 + 1
(On) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Release 3.5
June 2010