Technical data

Rerouting 1-180
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
ADMIN PROGRAMMING
Enable Allow Off-Network Call Forward
Access Authorization Code Table
Use PGM 227 … see page 1-20.
Enable Call Forward
Set Call Forward No Answer Timer
Set Off-net Call Mode
Set Unsupervised Conference Timer
Use PGM 182, then FLEX 6 … see page 1-87.
Off-net Call Forward -- if value is set to ENABLE, off-net call
forward can be used
PGM 111 + FLEX 18 + 0
(Enable) + [HOLD/SAVE]
VALUES --
0 = Enable
1 = Disable
Call Forward -- if value is set to ON, an incoming call can be
forwarded to another destination.
PGM 111 + FLEX 2 + 0
(Off) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Call Forward No Answer Timer -- if a value is set for no
answer call forward, when the station does not answer,
the call will be routed to the assigned forward destination
following expiration of this timer.
PGM 181 + FLEX 1 +
015 seconds (3 digits)
+ [HOLD/SAVE]
VALUES --
Range = 000-255
Off-net Call Mode -- if value is set to EXT, the
station user can only forward CO calls to off-net
(ex., mobile phone). Otherwise both CO and
ICM calls can be forwarded to Off-net.
PGM 112 + FLEX 12 + 0
(ALL) + [HOLD/SAVE]
VALUES -
1 = EXT (only external
Off-net Call Fwd is allowed
0 = ALL (internal & external
Off-net Call Fwd is allowed)
Release 3.5
June 2010