Technical data

Paging 1-176
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
To assign Meet-me Page at a Flex button:
1. Press [TRANS/PGM], then press the Flex button to be assigned.
2. Enter 544, then press [HOLD/SAVE] to store the setting.
To respond a Meet-me Page:
1. Lift the handset.
2. Enter 544 (the Meet-me Page code).
NOTE: For a Nomad IP, enter 544, then press [Send].
3. Press [HOLD/SAVE] to connect to the paging party.
Pre-recorded (VMIB) Message
You can record a VMIB message for paging.
CONDITIONS
• The handset must be lifted to both record and send a VMIB message for paging.
• If a recorded message is stored, it will be sent over the paging system. However, if no
message is stored, the user's "live" page can be made.
ADMIN PROGRAMMING
Set Paging Timeout Timer
OPERATION / SETUP
To record a VMIB paging message:
1. Press [TRANS/PGM], then enter 65.
The announcement "Press # button to record" plays. Or, if there is already a stored
message, the recorded message plays.
2. Press # button to start recording (a new message and/or overwrite existing message).
The announcement "Record your message" and the confirmation tone sounds.
3. Record the message for use when paging.
4. Press [HOLD/SAVE] or [SPEAKER] to store the message.
A confirmation tone sounds.
Paging Timeout Timer -- designates the maximum time
for a page. The system will automatically disconnect the
page when the timer expires.
PGM 181 + FLEX 10 +
015 seconds (3 digits) +
[HOLD/SAVE]
VALUES --
Range = 000-255
Release 3.5
June 2010