Technical data

Paging 1-175
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
ADMIN PROGRAMMING
Set Paging Timeout Timer
Enable Page Warning Tone
Enable Page Access
Set Internal Page Zones
Set External Control Contact
Use PGM 168 … see page 1-92.
OPERATION / SETUP
To initialize a page:
1. Lift the handset.
2. Dial the appropriate paging code.
3. After the page warning tone sounds (if applicable), make the announcement.
4. Replace the handset.
Paging Timeout Timer -- designates the maximum time for a
page. The system will automatically disconnect the page
when the timer expires.
PGM 181 + FLEX 10 +
015 seconds (3 digits)
+ [HOLD/SAVE]
VALUES --
Range = 000-25
Page Warning Tone -- if value is set to ON, a page warning
tone will be heard when paging starts.
PGM 161 + FLEX 4 + 1
(On) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Page Access -- if value is set to ON, the station can page
another Station.
PGM 111 + FLEX 8 + 0
(Off) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Internal Page Zone -- each station can be assigned to
internal page zone. SBX IP supports 10 internal paging
zones. All stations are assigned to Internal Page Zone 1 by
default.
PGM 118 + FLEX 1-5
(Zone 01-05, toggle)
+ [HOLD/SAVE]
VALUES --
Default = Zone 01
Release 3.5
June 2010